Even if it is kept, many out-of-the-box Spec forms that should have it referenced even though the Process Engr Module uses it while the Spec doesnt use it. PD_GAS_SG_AS_MM) fields makes creation and maintenance of the Spec Forms difficult. This field would be a good candidate to be an independent Table with USER defined lists as seen in the Index Module.Item 13 Use of two (2) Specific Gravity (PD_General. This may need to be added to the Component Table with choices like Loop Powered 24VDC, 120VAC External, 24VDC Externaletc. Item 7 Ensure that the Area Classification Field is on each Specification SheetItem 8 Ensure that Design Pressure and Temperature is on each Spec Sheet Item 9 Ensure that UDF Fields are standardized across all Specification FormsItem 10 Process Data Remarks are incorporated into the Spec Sheet NotesĬommittee General RecommendationsItem 11 Ensure that all Transmitter Specification Sheets have an Output Signal Type Field consistently.Item 12 Instruments that always require Power should have it included on the Specification Sheet. Project Name FieldClient Project Number FieldEngineering Project Number Field Item 5 Ensure that all Switch devices have Set Point field with Engineering units Item 6 Ensure that the following are included in the Specification Sheet Header: Supplement the existing field called PD_FAILURE_ACTION or Renaming the current field to PD_EL_FAILURE_ACTION field is on every Specification Form Item 2 Ensure that Range Fields exist for Flow, Level and Pressure devices Item 3 Ensure that all Title Blocks have By / Checked / Approved SignaturesItem 4 Ensure that AIR_FAILURE_POSITION is added to forms. This write up is a review of the default Spec Sheets available from the Specification Sheet Module, and recommendations on how these default forms can be improved.Ĭommittee General RecommendationsItem 1 Ensure that the P&ID No.
INTERGRAPH INTOOLS LOGO SOFTWARE
There has been a need for a software package that standardizes specification sheets used to acquire instrumentation at a plant site, and then tracking changes for the life of the instrument. IntroductionThe Intergraph INtools software package has been adopted by manyE&C (Engineering and Construction) and Operating Companies worldwide.
Instrumentation and Electrical Technical User Forum of Houston Specification Sheet Recommendations forINTERGRAPH INtoolsĪBB Lummus Global Betty AlexanderABB Lummus Global Arturo DuenasBayer Corporation Jamie GramzJacobs John BolmanskiMustang Engineering Inc.